If you don’t get any power check continuity between the turn signal and the SAM module. Measure voltage at the turn signal socket.Turn the turn signal switch or hazard lights on.Set the digital multimeter to DC voltage current.You need to use a digital multimeter to test for power at the headlight/taillight.If you keep having the problem where the turn signal socket keep melting try adding a ground from the tail light to the frame.Ĭheck for power at the turn signal assembly If it the turn signal fails within a few weeks, replaces the socket or the turn signal assembly if necessary. If this is your problem, try using sandpaper to clean the socket and try reinstalling it. The socket contact points heat up to the point where they start to melt. We have seen cases where the turn signal stopped working due to inadequate electrical contact between the turn signal bulb socket and the headlamp housing. Clean it electrical contact cleaner if necessary. Remove the electrical plug from the turn signal unit that is not working and inspect it. The electrical plug that plugs into the headlight or taillight assembly may be loose or not making good contact. Replace the light bulb with a new bulb that has the recommended wattage and bulb type. burned turn signal contact may heat up and melt the plastic which covers the contact points.a bad headlight / taillight electrical plug / connector / harness.It could be one of the turn signals located in the front, rear or side mirror housing.Īny of the following may cause Mercedes turn signal not working problems: 1 – Left or Right Mercedes Turn signal not working
.jpg "mercedes c230 kompressor 2004 wiper control arm")
The switch can get stuck and prohibit the turn signals from operating properly. Press the hazard warning switch on and off several times. You can swap the turn signal replay with another relay in the fuse box that is identical.
#MERCEDES C230 KOMPRESSOR 2004 WIPER CONTROL ARM MANUAL#
Look in the owner’s manual to find the location of the fuse panels for your Mercedes.Ģ.
Check the turn signal fuses in your fuse panel under the dash and engine compartment.
0 kommentar(er)
